Aero 3D Printed Products
Custom Items
If you need any specialty plastic items for your airplane such as face plates, holes covers, knobs, etc. Give me a call or email and I'll quote you a price.
Below are some of the in-stock items that are usually needed the most.

Double Knob Instrument Hole Cover
I recently did an install on an airplane and had to find an instrument hole cover for an old instrument that had 2 control knobs. I simply could not find a commercially supplied cover for this type of instrument hole, so I took the time to design and print a few.

 
3D printed cover. Fitted into instrument cutout. Wrinkle finished the cover and used it to install a Flightcom intercom.

Price does not include painting. Paint it to match the airplane.

Single hole covers also available for the same price.

Price is $15.00 + $9.30 Priority Mail

Send an email if you would like to purchase one or call 602-361-5405 for more details.


Wedge Mount for iPad / Garmin 696/796 etc.

The best place to install a navigation tablet is to your left on the side panel below the windshield as shown below. The gimballed accessories that come with the tablets are too large to allow it to fit snuggley.
This setup consists of an aircraft aluminium plate fastened to the side panel. Then there are 4 washers and a wedge set at 25°. The 4 washers fit between your tablet' mounting plate which is removed from the gimballed set, and then the large wedge fits in the back. The large wedge is used to allow the screws that hold everything together to be at 90° to the washers, and provide a firm surface for the mounting plate to prevent wobble in flight.

You can put the large wedge next to the tablets mounting plate, but usually the surface isn't flat enough.

Garmin 796 Mounted in a 1951 Cessna 170A. Solid Wedge and Washers hot off the 3D Printer. Glazed ready for paint, or leave as is.
Price does not include the tablet mounting plate, the metal plate and hardware which has to be customized to fit the airplane.
Price is $25.00 + $9.30 Priority Mail
Send an email if you would like to purchase one or call 602-361-5405 for more details.


2 Hole Surface Mounted Mic & Phone Jack Housing
These types of mounts are usually used to provide a place to plug in headsets for the rear passengers.
I have always thought that these mounts were over priced at $18.65 each. I can also print these mounts at any angle or size you need. I printed an extra high one for a customer so the headphone wires cleared the aircraft frame.
 
Shown with mic and phone jacks installed.
Price includes 2 headset brackets.
Price does not include painting or the jacks. You can paint it to match the interior.
Price is $25.00 a Pair + $9.30 Priority Mail
Send an email if you would like to purchase one or call 602-361-5405 for more details.